Tiler WHS Documents in Queensland
Written to Queensland legislation · delivered in about 4 minutes · free revision within 24h
A tiler starting on a Queensland site is asked for a set of documents, not just a SWMS. This page covers the whole set: what each document is, who asks for it and when, and what happens if you turn up without it. Workplace Health and Safety Queensland is the regulator here and the Work Health and Safety Regulation 2011 (Qld) is the law each document has to be written against.
The WHS documents a tiler needs in Queensland
- ✓ A site-specific SWMS for each high risk activity, cited to the Work Health and Safety Regulation 2011 (Qld) (WHS Regulation 2011 (Qld) reg 299)
- ✓ A SWMS register indexing every document, version and review date
- ✓ High risk work licences and tiler trade licences recognised in Queensland
- ✓ Safety Data Sheets for hazardous chemicals, and a chemical register
- ✓ Site induction record and daily sign-on / SWMS acknowledgement sheets
The SWMS a tiler usually needs
One SWMS per high risk construction work activity. The Trade SWMS Pack generates all of them, cited to Queensland law:
- ✓ Tile cutting and grinding with silica dust controls
- ✓ Bathroom and wet area tiling with waterproofing membranes
- ✓ Balcony and external tiling above 2 m
- ✓ Floor grinding and surface preparation
- ✓ Stairwell and void-edge tiling
- ✓ Large format tile handling and installation
The Queensland law behind it
| Regulator | Workplace Health and Safety Queensland |
| Principal Act | Work Health and Safety Act 2011 (Qld) |
| Regulations | Work Health and Safety Regulation 2011 (Qld) |
| Duty to prepare a SWMS | WHS Regulation 2011 (Qld) reg 299 |
| High risk construction work defined in | WHS Regulation 2011 (Qld) reg 291 |
Electrical work in Queensland is regulated separately under the Electrical Safety Act 2002 (Qld) and Electrical Safety Regulation 2013, which sit alongside the WHS Regulation, so electrical SWMS on Queensland sites should account for both regimes.
Queensland was the first state to enact an industrial manslaughter offence (2017, s 34C WHS Act 2011 (Qld)) and recorded Australia's first conviction in 2020; the maximum penalty is 20 years imprisonment for an individual or a $10 million fine for a body corporate. That is the enforcement backdrop your WHS document set has to stand up to on a Queensland site.
The hazards these documents have to control
A tiler SWMS in Queensland is judged on whether it names and controls the hazards the trade actually meets:
- ⚠ Silica dust from tile cutting and grinding
- ⚠ Falls from balconies and stair voids
- ⚠ Adhesive and epoxy exposure
- ⚠ Knee and back strain
- ⚠ Wet area slips
The high risk work that triggers a tiler's SWMS
- ✓ Risk of a person falling more than 2 metres
Every SWMS a tiler needs in Queensland, in one go
The Trade SWMS Pack generates all 6 SWMS above from one questionnaire, cited to Queensland law, plus the register, toolbox talks and sign-on sheets, for A$179.
See the Trade SWMS PackKeep exploring
Tiler WHS documents (all states)Tiler SWMS for QLDSWMS requirements by stateTrade SWMS Pack
Tiler WHS documents in other states: